Precision equipment should never be fragile — constant clogging and corrosion makes maintenance more time-consuming than production itself. The ultrasonic atomizer (超音波ネブライザ) was designed with this in mind: its relatively large feed channel and orifice fundamentally reduce clogging, while the clog-free, corrosion-resistant construction keeps routine maintenance simple. A few upkeep essentials are all it takes to keep atomization quality stable for the long term and maintenance costs down.
Working principle: The ultrasonic generator converts 50/60Hz electrical energy into high-frequency electrical energy, which is delivered to the piezoelectric crystal in the transducer and transformed into high-frequency mechanical vibration. The vibration is amplified by the booster and focused at the nozzle tip — the atomizing orifice. Liquid flows through the booster to the tip, where the high-frequency vibrating tip breaks it into tiny droplets, ejected by air pressure as a slow, soft, uniform mist. Unlike conventional atomizing heads that rely on pressure and high-speed motion to shatter liquid, the ultrasonic atomizer uses relatively low ultrasonic vibration energy. Liquid can be fed by gravity or a low-pressure pump for continuous or intermittent atomization. Atomization throughput depends on liquid feed rate and the atomizer's operating frequency; generally, higher frequency means lower processing capacity, with minimum atomization rates down to 2μl/s. For best results, liquid viscosity should be below 50cps and solids content below 30%. Compared with conventional pressure nozzles, the ultrasonic atomizer's feed channel and orifice are relatively large, achieving clog-free spraying. Droplet size is a function of the transducer's operating frequency — higher frequency means smaller droplets: about 40μm average diameter below 70kHz, and 30μm above 70kHz.
Applications: FPD & TFT display devices, fuel cells, energy (solar photovoltaic cells, lithium battery film deposition), optical lens coating, medical devices (implant coatings, vascular stent coatings, blood collection tube coatings) and more.
Key advantages: reduced material consumption, no overspray waste, intermittent or continuous operation, ultra-low atomization flow rates, clog-free and corrosion-resistant, high precision, high controllability.
Three daily essentials: first, keep liquid viscosity below 50cps and solids content under 30% — the prerequisite for good atomization and a light load on the nozzle; second, choose continuous or intermittent mode sensibly by production schedule to avoid needless idle running; third, clean the feed channel promptly after shutdown so residual liquid never dries and cakes. The clog-free design already minimizes maintenance workload — follow these points and the unit will run stably for years, delivering consistently uniform, delicate atomization.