The short answer is ultrasonic welding. The housings of mobile phone chargers, laptop power adapters and electric vehicle chargers are usually made of ABS or similar thermoplastics. The two halves are pressed together and welded in a single ultrasonic cycle — no screws, no glue — and the weld usually takes less than a second, sealing the housing to a water- and air-tight standard with no visible screw holes.

1. Why does ultrasonic welding suit charger housings?

Ultrasonic welding transmits high-frequency vibration to the joint, where friction melts the contact surfaces; a short hold under pressure then completes the bond. Charger housings are compact and their weld line is a closed loop around the shell, which is ideal for a single ultrasonic shot. No adhesive means no curing wait, which suits line production, and the joint is strong — close to the strength of the parent plastic — without the gaps that screw fixing leaves for dust to enter. A finished housing can be leak-tested directly: pressurise it and watch whether the pressure holds, which shows whether the seam leaks.

2. What should be checked before welding?

First, the material. ABS is the most common charger housing resin and one of the easiest to weld ultrasonically. For PC/ABS or other resins, the two halves must be able to fuse with each other — dissimilar plastics generally do not weld — so confirm the housing material first. Second, the joint: the mating rim needs an energy director so the vibration concentrates on the weld line instead of spreading across the shell. Check the shells for warpage as well: if the two halves do not close evenly, the seam will have gaps and weld unevenly. Third, the parts inside: the circuit board and other components must be fixed in place and kept clear of the weld line, because ultrasonic vibration can loosen or damage small internal parts if the design leaves no margin.

3. Why do welds fail?

Cracked seams, unwelded spots and excessive flash usually trace to three things: a missing or undersized energy director that lets the energy spread; parameters out of balance — too little weld time leaves the joint unfused, too much causes flash and burn marks; or a horn whose contour does not match the shell, giving uneven pressure. Work through joint, parameters and horn in that order rather than forcing one setting.

4. What should buyers check when selecting equipment?

Reports on dedicated charger welders commonly cite 15 kHz machines, while smaller housings may also suit 20 kHz; the right frequency and power depend on housing size, wall thickness and material. The fixture must follow the shell shape — the lower half firmly supported, the upper half located precisely — or the halves will shift. The safest step is a trial weld with the actual housings, followed by pull and sealing checks, before committing to volume; besides pull and sealing checks, a drop test is worth doing on the trial parts, to mimic the knocks a charger takes in everyday use. If you are selecting ultrasonic welding equipment for charger or power adapter housings, feel free to contact Shanghai Jingjin for a free welding sample test.