The short answer is that most scuff marks can be fixed, and usually without replacing the equipment. Marks generally appear in three places: the surface under the horn, the surface resting on the fixture, and the middle of thin-walled parts, where vibration can leave a burn mark. Identify where the mark is first, then work through the four steps below — in most cases adjusting parameters, adding a film, or dressing the horn solves it.

1. Where do scuff marks come from?

The horn presses on the plastic part while vibrating tens of thousands of times per second, so any mismatch between the horn face and the part surface will rub a mark into it. Textured parts are the most vulnerable: the raised texture forms small contact points where ultrasonic energy concentrates, and the texture gets polished flat and shiny. An aluminium horn can leave a different mark: untreated aluminium gives off aluminium oxide, which shows up as black residue on white or light-coloured parts. The fixture side is the same story: a rigid aluminium nest whose contour does not match the part will scar the plastic as it vibrates. Thin walls can also suffer a burn in the middle, where the part flexes like a diaphragm and heats up.

2. Four fixes that work fastest

First, lower the pressure. In ultrasonic welding pressure only holds the parts in place — it does not make the weld — and too much pressure is the most common cause of marks, so bring it down as far as the weld strength allows. Second, shorten the weld time and trigger the vibration earlier, cutting the delay so energy spends less time on the part surface. Third, put a thin film between the horn and the part, for example a PE film; glossy parts can also carry a PET protective film that is peeled off after welding. Fourth, check the horn face: keep it clean and polished to match the part, and have it hardened or chrome-plated where needed — a chrome-plated aluminium horn avoids the black residue problem, and a horn face with nicks or damage lines will print those marks onto every part.

3. Fixture and design fixes

A fixture should follow the part contour closely; the better the fit, the fewer the pressure marks. For parts that crack or break easily, the fixture can be made with a cushion — a soft resin insert or a cork pad — as long as it does not weaken the weld. Cast urethane fixtures work well for rigid amorphous parts: they support the part firmly while reducing marking. On the part design side, adding a radius at sharp corners reduces stress concentration and stops small features from cracking or breaking off under vibration.

4. When to repair the horn or remake the fixture

If the mark always appears in the same spot, check whether the horn contour matches the part there; horn edges need a generous radius, because a sharp edge leaves a witness line. If burn marks keep appearing in the middle of a thin-walled part, a nodal plunger inside the horn can damp the centre and stop the diaphragm effect. If none of this clears the marks, the cause is probably in the joint design or the parameters — or bring the actual parts for a trial weld. If scuff or burn marks are troubling your ultrasonic welding, feel free to contact Shanghai Jingjin for a free welding sample test, and we will help find the cause.