Selecting an ultrasonic atomizer comes down to four key points: first, droplet size — governed by operating frequency, with higher frequencies producing smaller droplets (about 40μm average diameter below 70kHz, 30μm above), so choose frequency by coating fineness requirements; second, liquid properties — viscosity should stay below 50cps and solids content under 30%, or atomization quality suffers; third, flow requirements — minimum atomization rates reach 2μl/s, so confirm capacity against your liquid feed rate; fourth, operating mode — continuous or intermittent atomization to match your production tempo. Check these four against your process, and selection becomes straightforward.
Working principle: The ultrasonic generator converts 50/60Hz electrical energy into high-frequency electrical energy, which is delivered to the piezoelectric crystal in the transducer and transformed into high-frequency mechanical vibration. The vibration is amplified by the booster and focused at the nozzle tip — the atomizing orifice. Liquid flows through the booster to the tip, where the high-frequency vibrating tip breaks it into tiny droplets, ejected by air pressure as a slow, soft, uniform mist. Unlike conventional atomizing heads that rely on pressure and high-speed motion to shatter liquid, the ultrasonic atomizer (超音波ネブライザ) uses relatively low ultrasonic vibration energy. Liquid can be fed by gravity or a low-pressure pump for continuous or intermittent atomization. Atomization throughput depends on liquid feed rate and the atomizer's operating frequency; generally, higher frequency means lower processing capacity, with minimum atomization rates down to 2μl/s. For best results, liquid viscosity should be below 50cps and solids content below 30%. Compared with conventional pressure nozzles, the ultrasonic atomizer's feed channel and orifice are relatively large, achieving clog-free spraying. Droplet size is a function of the transducer's operating frequency — higher frequency means smaller droplets: about 40μm average diameter below 70kHz, and 30μm above 70kHz.
Applications: FPD & TFT display devices, fuel cells, energy (solar photovoltaic cells, lithium battery film deposition), optical lens coating, medical devices (implant coatings, vascular stent coatings, blood collection tube coatings) and more.
Key advantages: reduced material consumption, no overspray waste, intermittent or continuous operation, ultra-low atomization flow rates, clog-free and corrosion-resistant, high precision, high controllability.
Questions about matching frequency to droplet size or liquid suitability? Share your liquid characteristics and process requirements — Jingjin Precision Machinery can help verify the feasibility of an atomization solution and guide you to the right equipment.