Blood Collection Tube Ultrasonic Spray Atomization
To understand why the ultrasonic atomizer (超音波ネブライザ) achieves such fine, uniform spraying, start with its energy conversion chain: the process never relies on high-pressure gas. Instead, electrical energy is converted step by step into controlled high-frequency mechanical vibration, which then shakes liquid into uniform micron-sized droplets. This gentle atomizing mechanism is exactly why it stands out in demanding applications such as inner-wall coating of blood collection tubes.
Working principle: The ultrasonic generator converts 50/60Hz electrical energy into high-frequency electrical energy, which is delivered to the piezoelectric crystal in the transducer and transformed into high-frequency mechanical vibration. The vibration is amplified by the booster and focused at the nozzle tip — the atomizing orifice. Liquid flows through the booster to the tip, where the high-frequency vibrating tip breaks it into tiny droplets, ejected by air pressure as a slow, soft, uniform mist. Unlike conventional atomizing heads that rely on pressure and high-speed motion to shatter liquid, the ultrasonic atomizer uses relatively low ultrasonic vibration energy. Liquid can be fed by gravity or a low-pressure pump for continuous or intermittent atomization. Atomization throughput depends on liquid feed rate and the atomizer's operating frequency; generally, higher frequency means lower processing capacity, with minimum atomization rates down to 2μl/s. For best results, liquid viscosity should be below 50cps and solids content below 30%. Compared with conventional pressure nozzles, the ultrasonic atomizer's feed channel and orifice are relatively large, achieving clog-free spraying. Droplet size is a function of the transducer's operating frequency — higher frequency means smaller droplets: about 40μm average diameter below 70kHz, and 30μm above 70kHz.
Applications: FPD & TFT display devices, fuel cells, energy (solar photovoltaic cells, lithium battery film deposition), optical lens coating, medical devices (implant coatings, vascular stent coatings, blood collection tube coatings) and more.
Key advantages: reduced material consumption, no overspray waste, intermittent or continuous operation, ultra-low atomization flow rates, clog-free and corrosion-resistant, high precision, high controllability.
Once you grasp this principle, its operating envelope makes sense: atomization quality depends on matching liquid feed rate to operating frequency, with viscosity below 50cps and solids under 30% for best results. Get these key points right, and the ultrasonic atomizer will deliver uniform, delicate atomization over the long term.