Laser Plastic Welding Process in the Automotive Industry:
In the automotive industry, laser technology is mainly used for tailored blank welding, body welding, and parts welding. Laser tailored blank welding means that, in body design and manufacturing, steel sheets of different specifications are selected according to the body's different design and performance requirements, and a particular body section — such as the windshield frame, door inner panel, body floor, or B-pillar — is produced through laser cutting and assembly. Laser tailored blank welding reduces the number of parts and dies, reduces the number of spot welds, optimizes material usage, lowers part weight, cuts costs, and improves dimensional accuracy, and has already been adopted by many major automakers and parts suppliers. Laser welding is mainly used for welding body frame structures, such as the roof to the side body — resistance spot welding, the traditional method, is gradually being replaced by laser welding. With laser welding technology, the joint width between connected workpieces can be reduced, which both lowers sheet metal usage and increases body rigidity. Laser-welded parts show almost no deformation at the weld, weld fast, and need no post-weld heat treatment. Laser welding of parts is already widely used, commonly seen in transmission gears, valve lifters, door hinges, and the like. Currently there are two new forms of laser welding: laser hybrid welding and dual-focus laser welding. Applying laser welding to automobiles reduces body weight, improves body assembly accuracy, increases body rigidity, lowers stamping and assembly costs in body manufacturing, and reduces the number of body parts while integrating them — all highly worthwhile.
Laser Contour Welding:
Contour welding is welding completed by relative movement between the parts to be welded and the laser beam along a programmed path. The relative movement is accomplished by rotary axes, linear axes, or robots; as the path advances, the welding material fuses progressively to complete the weld. With this method, the weld width ranges from a few tenths of a millimeter to several millimeters, depending on the laser mode and focusing system.
This process is highly flexible and can perform complex, three-dimensional contour welding. Part size is limited only by the fixtures used to hold the parts, so large parts can be welded. The drawback of this method is that localized melting of the polymer causes expansion and deformation, leading to dimensional deviations in the welded parts. Contour welding is mainly used for spin welding of symmetrical joints or for welding large parts where spatter and residue are not allowed.
Laser Scanning Welding:
Galvanometer scanning welding combines contour welding and simultaneous welding. Compared with contour welding, the focused laser beam moves along the weld seam faster. This method can heat and melt the entire weld seam at once, heating the seam more uniformly and compensating for geometric dimensional errors of the welded workpieces. It also produces less spatter.
This process has a much shorter cycle time than contour welding. Due to the limited scanning range of the galvanometer, part size cannot exceed 230 x 230 mm, but larger parts can be welded by using multiple galvanometers. Scanning welding cannot perform complex three-dimensional welding; it suits welding with short cycle times, small parts, or welds where the weld path needs monitoring for quality control.