1. Regular inspection of the ultrasonic lace sewing machine horn
(1) The parallelism between the horn face and the anvil wheel should be checked regularly; generally the parallelism must be less than 0.02 mm, and the machine should only be operated after adjustment if this standard is exceeded.
(2) If the horn's working face wears and develops dents so that fabrics no longer cut cleanly, the horn must be removed, its working face ground flat, and then reinstalled.
Note: a horn can be reground several times, but the cumulative grinding depth must not exceed 2 mm; otherwise the horn will be scrapped because its working frequency changes and its surface hardened layer disappears.
(3) Checking that the ultrasonic lace sewing machine horn matches the working frequency of the ultrasonic generator assembly:
Note: check this every morning before work. Method: switch on the power, then flip the test switch plate toward "ultrasonic test" and watch — if any of the following occurs, the frequency should be corrected:
A. Touching the horn's working face lightly by hand, the ultrasonic amplitude feels weak; B. abnormal noise occurs; C. the horn gets abnormally hot; D. the ammeter on the generator assembly panel swings too widely.
Adjustment: using a flat-head screwdriver on the tuner on the panel, fine-tune the frequency one step at a time (generally no more than 45° clockwise or counterclockwise) until the ammeter pointer swings the least and the above symptoms disappear.
If the machine still cannot work after correction, do not press the foot switch; cut the power and stop work, or the equipment will be damaged.
2. Anvil wheel inspection for the ultrasonic lace sewing machine
The anvil wheel's pattern must stay sharp, with hardness kept at Rockwell 50–55. Inferior, worn or rust-pitted anvil wheels must not be used, to avoid harming product quality or accelerating horn wear by mistakenly increasing the anvil wheel pressure.
3. Pressure control for the ultrasonic lace sewing machine
The pressure the machine needs during work is generally decided by the following factors:
(1) The more complex the anvil wheel pattern, the slightly greater the pressure needed.
(2) The duller the anvil wheel pattern, the slightly greater the pressure needed.
(3) The smaller the horn's acoustic amplitude, the slightly greater the pressure needed.
(4) For the fabric being processed, materials with higher synthetic-fiber content (e.g. NYLON) can take less pressure; otherwise (e.g. IC fabric) pressure should be slightly greater.
(5) For fabric thickness, thicker fabrics need slightly greater pressure.
(6) For processing speed, higher speeds need slightly greater pressure.
Note: if processed products develop quality problems, find the real cause of the quality issue — never solve it by simply increasing the anvil wheel pressure. Chasing pressure alone very easily causes fast wear of the horn face or the anvil wheel pattern and other faults, so as long as the processed product quality is good, the pressure should be kept as low as possible.
4. On the ultrasonic lace sewing machine, if the ammeter on the ultrasonic generator assembly panel reads above 1.2 A at no load, the generator frequency has drifted or is abnormal — stop the machine and correct the frequency or inspect it before use.
5. The ultrasonic generator assembly of the ultrasonic lace sewing machine is sensitive to stable rated input voltage; an automatic electronic voltage stabilizer is recommended.