Hot Gas Welding:
Hot gas welding is similar to oxyacetylene welding of metals, except the latter uses an open flame while the former uses a hot gas stream for heating. During hot gas welding, the hot gas stream from the welding gun (typically 200–300 °C, flow rate 15–60 L/min) heats the filler rod and the workpiece simultaneously; when the material surface softens to a tacky state, the filler rod is continuously pressed into the weld. The filler rod material is identical in composition to the base material and is usually round (about 3 mm in diameter); thick plates are welded with multiple passes. One drawback of round filler rods is that air bubbles are easily trapped in the weld during multi-pass welding, reducing strength—this can be solved by using triangular-section welding rods.
Compressed air is the most common gas used as the heat-source carrier in hot gas welding because it is inexpensive and gives satisfactory results in many cases. Nitrogen is used for welding oxidation-sensitive plastics such as polyethylene. Typical materials weldable by hot gas welding include PVC, polyethylene, polypropylene, acrylic, polycarbonate, polyoxymethylene, polystyrene, nylon, ABS, and others.
The main advantage of hot gas welding is its strong adaptability (flexibility): large, complex parts can be processed with simple portable equipment. It suits irregular structures, but it is slow, and weld quality depends heavily on operator skill, so it is rarely used in mass production—though it is well suited to repair work.
Hot gas welding is typically used for long joints. Typical automotive applications include: reservoir liner seams, assembly of large thermoplastic ventilation ducts, manufacture of plastic oil (water) tanks, and joining or repair of plastic piping.
Hot Tool Welding:
Hot tool welding is one of the most widely used plastic welding methods. During welding, a heated metal tool is inserted between the two joint surfaces until the plastic reaches its melting temperature; the hot tool is then withdrawn, pressure is applied to the joint, and the melted surfaces are brought together to cool and solidify under controlled pressure, forming the weld. In the vast majority of cases the joint surfaces are flat (e.g., plastic pipe joints) and the hot tool used is a hot plate—in which case hot tool welding is called hot plate welding. In some cases, however, such as the doubly-curved joint interfaces of automotive headlamps and tail lamps, complex-shaped hot tools are required to match the contour of the joint surfaces.
Hot tools are made of metal and heated by internal tubular heating elements or heat-release elements. Temperature sensors allow precise control of the tool surface temperature. To prevent the molten plastic layer from sticking to the tool, the tool surface is coated with PTFE. A flat hot plate may be covered with PTFE-coated abrasive cloth (glass cloth), but these coatings limit the tool's maximum surface temperature to about 270 °C. Typical hot plate temperatures are 180–230 °C (depending on material type), but sometimes reach 500 °C. At higher temperatures, bronze-plated platens are required.
Joints in most materials are generally equivalent to the base material. Any plastic that can be heated and melted can be hot-tool welded. Hot tool welding can also join dissimilar materials, with the two parts of the assembly using different surface temperatures. A typical example is the welding of automotive tail lamps and reflectors (PMMA and ABS).
Typical automotive applications of hot tool welding include: radiator header tanks, hydraulic oil tanks, polypropylene-copolymer battery lamps, polyethylene fuel-tank filler pipes, interior and exterior trim parts and components, headlamps and tail lamps, toolboxes, etc.