The short answer is that weak weld strength rarely has a single cause, and it is rarely fixed by turning one knob. The usual causes fall into five groups: joint design, material, parameters, horn and fixture. Working through them in that order finds the fault far faster than trial-and-error on the settings.
1. Start with the joint design
Joint design is the most common cause of weak welds. Ultrasonic welding works by concentrating vibration energy on the weld line, and if two flat faces are pressed together with no energy director, the energy spreads across the whole contact area, melting slowly and unevenly, and the joint pulls apart by hand. An energy director that is too small or too large, uneven contact, gaps between the parts or insufficient collapse distance all cost strength. Semi-crystalline plastics — nylon, PP, POM — should not use an energy-director joint at all; they need a shear joint. Confirm the joint design first, then look elsewhere.
2. Then the material
Two plastics with very different melting points, chemical structures or stiffness may not fuse even when the settings look right, so confirm the materials are weld-compatible before anything else. Moisture-absorbing resins such as nylon and polycarbonate weld weakly when damp, because the trapped moisture turns to steam in the joint. Recycled content and resin batch variation can also change weldability. One cause that is easy to miss is mould wear: as the mould that makes the parts wears, the joint dimensions drift a little, and a small change in the shear width can make a large difference to weld quality, so the mould should be checked regularly in volume production.
3. Tune the parameters as a set
Ultrasonic welding parameters — amplitude, pressure, weld time, energy and hold time — work as a set, and raising one alone does not always add strength. Too little weld time leaves the joint unfused, too little amplitude starves it of energy, and pressure that is too high or too low both weaken the bond. Keep a written weld process sheet for every job: which product, which settings, what the result was. It makes the next fault far quicker to trace and keeps results consistent across shifts.
4. Check the horn and the fixture
If the horn does not contact the part properly, energy transfer becomes unstable and strength varies from part to part. Nicks, cracks or contamination on the horn face should be cleaned or dressed before anything else. The fixture must support the lower half and stop it deflecting under pressure; if the part deforms, the energy is spent on deformation instead of melting. If both halves vibrate together instead of rubbing against each other, the joint cannot generate enough frictional melt at all.
5. Still no cause found
When all five areas check out and strength is still inconsistent, go back to the actual parts: trial-weld with the real material and joint, change one condition at a time, and find which change moves the result most. If weak or inconsistent weld strength is troubling your line, feel free to contact Shanghai Jingjin for a free welding sample test, and we will help locate the cause.