Ultrasonic Plastic Welding Process:
The ultrasonic plastic welding machine is a product of high technology—a new-generation plastic processing and welding device built for high efficiency, high quality, and automation, integrating microcomputer, ultrasonic, electronic, and mechanical technologies. When welding plastic workpieces, ultrasonic welding needs no adhesives or solvents and no heat source, offering easy operation, fast welding speed, good weld quality, and environmental safety.
The mechanical drive and electrical control systems of the ultrasonic plastic welding machine are also quite advanced. First, the air compressor feeds air pressure of about 5 kg into the pneumatic valves; the electrical control system then controls the directional valves so the horn can be raised or lowered as needed. The electrical control system also governs pre-pressing, ultrasonic triggering, and weld hold time. The welder can additionally be fitted with a dedicated microcomputer control system for program-automated control of start-up, horn up/down movement, ultrasonic triggering, pre-pressing, and weld hold time, and for calculating, storing, and selecting the optimal ultrasonic power, pressure, and weld time parameters for different welding objects—so weld quality is reliably assured.
Since plastic welding objects differ in material, size, shape, and welding requirements—and since plastic weldability is further affected by elastic modulus, vibration resistance, friction coefficient, thermal conductivity, and melting temperature—a series of ultrasonic plastic welding processes have been developed to improve weld quality.
Ultrasonic Plastic Welding Methods:
1. Standard two-plane ultrasonic welding: a triangular bead spanning the entire weld surface is designed on the lower weld face to concentrate energy. For high-hardness materials with low melting points, the bead height must be at least 0.25 mm; for low-hardness materials with high melting points, at least 0.5 mm.
2. Grooved ultrasonic welding for molded parts: staggered (interference) welding is used to prevent overheating and decomposition at the joint. Since the mating surfaces maintain a certain gap, welding is more difficult; the mating surfaces should be designed with a given clearance to reduce precision requirements for the molded parts.
Ultrasonic cut-and-seal welding: suitable for welds requiring a complete seal, especially for crystalline resins such as nylon and high-density polyethylene. The process first melts the initial contact area, then, under the welder's controlled downforce, progressively melts the remaining material along the vertical shear face.
3. Ultrasonic insertion: a new process for embedding metal elements into plastic, replacing the old method of injection-molding around metal elements, which easily creates stress. In insertion, the tolerance fit between the plastic part and the inserted metal is generally about 0.4 mm. To increase pull-out resistance, the metal insert's surface can be knurled or threaded, or grooved with several narrow slots; for greater strength, its axial surface can be knurled. Two feasible insertion modes exist: one with the plastic part against the horn, the other with the metal insert against the horn.
4. Ultrasonic staking: uses controlled melting to form plastic studs, thereby fastening the other part of the assembly. Ultrasonic energy is applied to the top of the stud so the molten plastic fills the horn's cavity, forming a raised cap that locks the component. The horn should be lowered gently onto the stud to avoid accidental deformation from excessive instantaneous pressure. In the most common staking form, plastic melting starts at the tip of the horn cavity, and the horn diameter is generally designed at twice the stud diameter. For small-diameter studs and wear-resistant thermoplastics, a domed staking form is used; where appearance and holding strength requirements are low, a knurled staking form may be used; for parts whose weld surface must stay flat and flush, a flush staking form is used.