Conditions for ultrasonic welding:
    The most important conditions for ultrasonic welding are the duration of welding energy application (vibration, weld time) and pressure; of course, other conditions are also important.
    Welding temperature
    The viscous flow temperature of the ultrasonic welding material. Otherwise the material will not melt. It is related to amplitude: the higher the amplitude, the higher the temperature rise.
    Applied pressure
    Use a cylindrical horn to press the molded product. Generally the compressed air pressure is 0.1–0.3 MPa (gauge), sometimes higher. But high pressure will hinder the vibration of the cylinder.
    Weld time
    Varies with material type and product shape; some molded products need only 0.2 seconds of weld time. Too long a time causes over-welding with lots of flash and bubbles, leading to poor airtightness — be careful.
    Cooling (holding) time
    For crystalline plastics, if the temperature is below the melting point, the joint solidifies; usually the pressure is held for 0.1–0.2 seconds.
    Ultrasonic welder requirements:
    The welder's horn consists of three parts from bottom to top: horn, booster and transducer. The three amplify in a certain ratio. If the transducer amplitude is 6MM, the booster can triple it to 18MM, and the horn amplitude can reach 36MM. Of course, as amplitude increases, horn life decreases. Different materials need different amplitudes.
    Horn materials are generally three kinds:
    Titanium: expensive, best performance, good toughness, difficult to machine. Low friction loss; amplitude can reach 60MM;
    Aluminum alloy: cheap, wears fast, amplitude must not exceed 30MM, easy to machine;
    Steel: very hard, least suitable as a horn, amplitude must not exceed 25MM, suitable for cutting, needs an added air-blow pipe for cooling.
    Ultrasonic automotive welding applications: car door panels, car door sound insulation felt, spot welding of automotive non-woven interior parts, car dashboards, car instrument panels, riveting of automotive plastic parts, car bumpers, car wheel covers, car headliners, car trunk non-wovens, car seat cushion non-wovens, car engine covers, car tail lamps, car lamp shades, car bearing cages, car glove boxes, car filters, automotive plastic valves, car air diverters, car airflow sensors, etc. Welding of automotive plastic parts mostly uses non-standard ultrasonic welding equipment with multi-head, multi-station design, PCL program control and LCD display operation; for welding large, complex automotive workpieces with weld surfaces in different directions, multiple positions must be welded simultaneously.