Preparation before adjusting the ultrasonic welder and welding: 
  A First clean the booster (CONE), the horn (HORN) and the horn screw with alcohol or gasoline, then apply a thin layer of grease to the mating surfaces of the horn screw, booster and horn, and lock the horn screw onto the horn. (Note: if the mating surfaces of the booster and horn are damaged, vibration transmission efficiency will decrease — maintain them carefully.)   
  B Turn the machine lifting handwheel to raise the machine to a suitable position (about 300 mm of space below the booster mating surface), then fix the four base leveling screws, securing the booster at the middle of its rotation range. 
  C Screw the horn into the booster by hand until it cannot turn any further. 
  D Tighten the horn with the horn locking wrench (to about 300 kg/cm of torque), taking special care not to let the booster rotate, to avoid snapping the alignment pin. (If rotation occurs, tighten the four transducer cover screws further, or hold the booster with another horn locking wrench.)