1. Thermal resistance must bring the workpiece to its melting point
The ultrasonic transducer converts electrical energy into mechanical energy, which is conducted through the molecules of the workpiece material. Ultrasonic waves conduct through solids with far less acoustic resistance than through air; when the wave passes through the workpiece joint, the gap has high acoustic resistance and generates considerable heat. The temperature first reaches the workpiece's melting point, and with a certain pressure applied, the joint fuses. Other parts of the workpiece do not fuse because their thermal resistance is low and their temperature stays low.
2. The two workpieces must be weld-compatible
Some combinations of different materials weld very well, some are basically fusible, and some are incompatible. The same material has the same melting point, so in principle it can be welded — but when the melting point of the workpiece exceeds 350°C, ultrasonic welding is no longer suitable. Ultrasound melts the workpiece molecules instantaneously; the rule of thumb is that if a good weld cannot be achieved within 3 seconds, another welding process should be chosen, such as hot plate welding. Generally speaking, ABS is the easiest to weld, while nylon and PP are the hardest to fuse.
3. The joint area has certain requirements
When instantaneous energy is generated, the larger the joint area, the more the energy disperses and the worse the weld — it may even be impossible to weld. Also, ultrasound propagates longitudinally, and energy loss is proportional to distance, so long-distance welding should be kept within 6 cm. The weld line should preferably be controlled between 0.3 and 0.8 mm, and the workpiece wall thickness should not be less than 2 mm, otherwise a good weld cannot be achieved — especially for products requiring airtightness.
4. The ultrasonic welder's output power must be properly matched
The output power of an ultrasonic plastic welder is determined by the diameter, thickness, material, and design process of the piezoelectric ceramic discs. Once the ultrasonic transducer is finalized, the maximum power is set. Measuring the magnitude of output energy is a complex process — a bigger transducer or more ultrasonic power transistors in the circuit does not mean greater output energy. A fairly sophisticated amplitude measuring instrument is required to accurately measure amplitude.
5. Avoid misconceptions about ultrasonic welder models
How much output power, oscillation frequency, and amplitude range to use should be considered based on the workpiece material, weld line area, whether the workpiece contains electronic components, whether airtightness is required, and other factors. The belief that bigger power is always better is a misconception. If you are not very familiar with ultrasound, it is best to consult the engineering staff of a reputable ultrasonic equipment manufacturer. If possible, communicate with the manufacturer on site, and do not blindly follow the misleading claims of some irregular ultrasonic equipment salespeople.
6. The ultrasonic horn structure requires strict inspection
Reputable ultrasonic tooling manufacturers apply a strict incoming inspection procedure, and machining dimensions are simulated and verified with computer software before production — that is what guarantees quality. Small workshops generally cannot do this. Without proper design, a tool that shows no obvious problems when welding small workpieces will reveal all kinds of defects at high power, and in severe cases directly damage the power components.
In summary, correct use of an ultrasonic welding machine requires all six aspects working together: thermal resistance reaching the workpiece's melting point, weld compatibility of the two workpieces, proper joint area, matched welder output power, avoiding model-selection misconceptions, and strict inspection of the horn structure.
PreviousUltrasonic Welding Principles and Influencing FactorsNextTissue Culture Bottle Cap Welding Equipment