1. How an ultrasonic welding machine works 
   An electronic functional device converts the incoming 15/20 Hz line frequency into 20 kHz or 40 kHz high-frequency electrical energy, which is supplied to the converter. The converter turns the electrical energy into mechanical vibration energy for ultrasound; the booster assembly transmits the converted mechanical energy to the horn of the ultrasonic welding machine. The horn is an acoustic device that transmits mechanical vibration energy directly to the product to be pressed; vibration is transmitted through the weld workpiece to the bonding surface, where vibration friction generates heat that melts the plastic. Vibration stops when the molten material reaches its interface; briefly holding pressure allows the melt to solidify at the bonding surface, forming a strong molecular bond. The entire cycle is usually completed in less than a second, yet the weld strength is close to that of a single continuous piece of material. Ultrasonics can be used not only to weld rigid thermoplastics but also to process fabrics and films.
    The main components of an ultrasonic welding system are the ultrasonic generator, the transducer/booster/horn stack, the mold, and the frame.
     2. Factors affecting ultrasonic welding machines
    1. An ultrasonic welding machine generally cannot be used to weld plastics several millimeters thick (2–3 mm), although special conditions such as structure, weld method, and machine power may allow exceptions. 
    2. Weld results depend on surface finish — otherwise there would be no need for ultrasonic energy directors on plastic molds. An energy director is an ultrasonic melt-point positioning device, usually appearing on plastic molds as contact lines (or contact points). In the ultrasonic welding industry, energy-director positioning devices are collectively called energy directors.
    3. To embed a fine wire mesh between two plastic sheets, the mesh must be fixtured in position so it does not shift during welding. 
    4. When welding with a high-power ultrasonic welding machine, the plastic will not necessarily melt — it depends on the specific parameter settings. 
    5. Thermoplastic raw materials are ideal for ultrasonic welding; the most common are ABS, PVC, PC, acrylic, and more.