1. Welding Principle of the Hot Plate Welding Machine:
The hot plate welding machine mainly welds plastic parts with a temperature-controlled heating plate. During welding, the heating plate is placed between two plastic parts; when the workpieces press against the heating plate, the plastic begins to melt. After a preset heating time, the plastic on the workpiece surfaces reaches a certain degree of melting. The workpieces then separate, the heating plate moves away, and the two parts are brought together. After the hot plate stops acting, pressure is maintained for a few seconds to let the joint solidify, forming a strong molecular chain that achieves the weld. The weld strength can exceed that of the base material, and the entire welding process is complete.
2. Composition of the Hot Plate Welding Machine and the Function of Each Part:
The hot plate welding machine consists of the pneumatic drive section, the control section, the electrical section, the machine frame, and the hot plate tooling and mechanical devices.
1. Pneumatic drive section
This section includes: filters, pressure reducing valves, lubricators, directional valves, throttle valves, cylinders, etc.
When the hot plate welding machine works, an air compressor first drives the stroke cylinders to move the hot plate tooling system up and down. The pneumatic drive's air pressure during welding is set according to the plastic parts being welded.
2. Control section
The control section consists of a PLC and temperature controllers. Its main functions are: first, to control the pneumatic drive system so that during welding, under timed control, the air circuit valves open, the cylinders pressurize to lower the horn, pressing the parts to be welded with a certain pressure; after welding, pressure is held for a period of time, then the control system switches the air circuit valves so the horn rises and resets. Second, to control the heating time of the plastic parts on the hot plate. This system automates the entire welding process — the operator only presses the start button to generate a trigger pulse, and the full welding cycle completes automatically. The sequence of the whole control system is: power on — trigger control signal pneumatic drive system, cylinders pressurize, upper and lower clamping molds descend and press against the upper and lower hot plate molds, which begin working and maintain a certain fusing time continue holding pressure for a certain time release pressure, upper and lower clamping molds rise welding ends.
3. Electrical section
Touch screen and (programmable) controllers, magnetic switches, and electric heating tubes. The electrical section is mainly divided into two parts: the hot plate temperature control system and the programmed control system for the movements of the upper/lower platens and the hot plate mechanism. In the heating plate temperature control system, three-phase 380 V power is introduced through an air switch, and a temperature controller switches a three-phase solid-state relay (SSR) on and off to supply heating current to the electric heating tubes in the hot plate. A thermocouple buried in the electric heating plate feeds back the temperature signal to the temperature controller, achieving temperature control of the electric heating plate. The temperature controller intelligently controls the output current of the SSR. The system circuit also has two AC ammeters to monitor the on/off state and magnitude of the three-phase current. The heating temperature can be preset and adjusted on the temperature controller panel according to the heating plate's processing temperature requirements.
4. Tooling and mechanical device section
This section uses a slide-plate structure: heat from the heating plate is transferred by electric heating to the fusing surfaces of the upper and lower plastic heating parts, melting their surfaces. The heating plate is then quickly withdrawn, and the upper and lower plastic parts are quickly pressed together by 2 cylinders, so the heated fusing surfaces rapidly fuse and solidify into one. The whole machine has a frame structure composed of three modules: the upper mold fixed positioning structure, the lower mold fixed positioning structure, and the hot plate module. The machine is equipped with two copper electric heating plates, moved back and forth by cylinders, easy to use.
3. Block Diagram of the Equipment Working Process :
PreviousUltrasonic Lace Machine for Non-woven Bag MakingNextUltrasonic Welding Process for Plastic Composite Films