Hot Plate Welding
For joining plastics, hot plate welding is the simplest mass-production technique. A high-temperature hot plate is clamped between the surfaces to be joined until they soften. The hot plate is then withdrawn, and the two surfaces are brought together under controlled pressure and held for a specific time. The molten surfaces then cool to form the weld. The welding tool or heating element has built-in electric heaters to keep plastic from sticking to the tool. Temperature is generally between 180°C and 230°C, depending on the thickness and type of the material being welded. This welding method is commonly used to weld the ends of plastic pipes for gas, water, sewage, and drainage, and pipes used in the chemical industry, and to weld filler pipes and fittings to automotive blow-molded fuel tanks. Many everyday products use this welding process, such as vacuum cleaner housings, washing machine and dishwasher parts, brake fluid reservoirs, taillights, indicator lights, and other automotive components. The drawback of hot plate welding is its slow speed: small parts generally take 10–20 seconds, while large pipes can take up to 30 minutes.
Hot Gas Welding
Hot gas welding is similar to oxyacetylene metal welding. The only difference is that the open flame of oxyacetylene welding is replaced by a hot gas stream. Compressed air, nitrogen, hydrogen, oxygen, or carbon dioxide is heated by an electric heating coil as it passes through the welding gun. Hot gas welding is a fabrication process for assembling thermoplastic materials. Originating in the mid-20th century, this welding method uses a heated gas stream (usually air) to heat and melt the thermoplastic base material and thermoplastic welding rod. The melted base material and rod form the weld. To ensure effective welding, proper temperature and pressure must be applied to the rod, along with suitable welding speed and gun position. Main uses include chemical storage containers, ventilation ducts, and repair of injection-molded parts such as automotive bumpers. Nitrogen is used for oxygen-sensitive materials such as polyethylene; oxygen produces higher weld strength. Compressed air ensures good results at low cost and is therefore widely used in hot gas welding. Weldable plastics include PVC, polyethylene, polycarbonate, and nylon. The main advantage of this welding method is its ability to weld large, complex parts, but welding is slow and weld quality depends entirely on the welder's skill.
Implant Welding
In implant welding, a metal insert is first clamped between the parts to be joined, then heated by induction or resistance. With resistance welding, wires must be placed along the joint to conduct current into the implant; induction welding does not require this. The thermoplastic melts around the implant and flows around its perimeter to form the weld. Implant welding has been used to weld complex joints of large parts, including automotive bumpers, electric vehicles, and yacht hulls.
Laser Welding
Laser welding suits welding sheet films and molded thermoplastics. During welding, the laser beam melts the plastic in the joint zone. The laser emits an intense beam of radiation (usually in the infrared region of the electromagnetic spectrum), focused on the surface of the material to be joined. This creates a resonant frequency in the molecules, raising the temperature of the surrounding material. Laser welding is a mass-production process whose advantages include no vibration and minimal arc burn. Other advantages: controllable beam intensity minimizes part deformation or damage; the concentrated laser beam allows accurate joint forming; and the process is non-contact, clean, and hygienic. Laser welding suits both single and continuous welds, but the materials being welded must be clamped. Welding speed depends on the polymer's absorption rate. Laser welding is a viable solution that can replace conventional welding methods. In recent years, laser welding technology can even weld transparent materials.