Ultrasonic Welding Mold Debugging Steps
1. First turn on the working air pressure source of the ultrasonic equipment and make sure the equipment's air pressure gauge reads normally.
2. Use the special wrench to remove the existing welding mold from the equipment and install the ultrasonic mold for the product to be welded (clockwise loosens — remember it must be tightened).
3. Connect the power supply of the ultrasonic equipment, turn on the start button, wait five seconds, then turn off the power.
4. Immediately press the sound-wave test button on the controller and listen for the ultrasound emitted by the machine (the sound should be crisp, without hoarseness or extra noise). If the sound is hoarse or there is a squeal, check whether the mold is cracked or loose and take countermeasures.
5. Loosen the two fastening handles behind the machine frame and raise the machine head to a certain height (depending on product height).
6. Shut off the air supply (adjust the air pressure controller to "zero").
7. Place the product to be welded on the base mold and ensure the molds close together.
8. Pull down the whole mold's vibration cylinder so the upper mold approaches the base mold; rock the head lifting handle so the upper mold presses onto the product, keeping the product fitted with the upper and lower molds.
9. Raise the air pressure to 0.1 MPa, set the selector switch to manual, and press the two green start buttons to lower the mold and press it against the product.
10. Rock the lifter so the limit screw stays 1 mm from the vibration cylinder (adjust according to the product to be welded).
11. Tighten the frame fastening handles, fix the base mold, and press the red emergency stop button to raise the machine head.
12. Set the selector switch to automatic, adjust the product's welding parameters, and prepare for production.
If the product is unbalanced or shifts during production, adjust with the leveling nuts.