Safety precautions for ultrasonic welding machines:
    1. When adjusting the sonic selector screw, the amplitude meter pointer will swing left and right — this does not indicate the magnitude of the power output, only the degree of resonance between the oscillator system and the vibrating system. The smaller the scale reading, the better the resonance.
    2. During no-load oscillation the amplitude meter indicates resonance; under load it indicates output energy.    
    3. Always perform a sonic test before welding to ensure resonance between the oscillator system and the vibrating system.    
    4. After replacing the horn, always run the sonic test routine.    
    5. While adjusting, if the overload indicator lights up, immediately release the sonic test button, wait about 1 second, then turn the sonic adjusting screw to tune the sound.    
   6. Proper tuning is critical. If the machine cannot be tuned to normal condition and cannot meet item 5 of the sonic test routine , send it in for repair at once. Do not force it into use, or the fault will get worse.     
   7. Working air pressure must not exceed 5 kg/cm.
    Horn alignment procedure for ultrasonic plastic welding machines:  
    For maximum machine energy, keep the distance between the upper horn and the workpiece as short as possible, while still leaving enough room to load and unload the workpiece. The lift table's maximum stroke is 75 mm, so before alignment, make sure the upper horn will not touch the workpiece at maximum stroke.    
    a) Set the selector switch to manual and adjust the pressure regulator so the gauge reads about 0.2 MPa (roughly the minimum pressure that can lift the horn).    
    b) Place the lower horn on the worktable, then place the workpiece in the lower horn.     
    c) Release the machine's locking handle, turn the lifting handwheel so the gap between the upper horn and the workpiece exceeds 75 mm, and tighten the locking handle.     
    d) Press both down buttons with both hands to lower the upper horn.    
    e) Loosen the four horn mounting screws, rotate the upper horn to match the workpiece, then re-tighten the four screws. 
    f) Loosen the stop screw and rotate it (M12×1) until it contacts the lift table. Press the emergency raise button to raise the upper horn, then back the stop screw off by about 7 mm.    
    g) Press both down buttons with both hands to lower the upper horn. Release the machine's locking handle, turn the lifting handwheel to slowly lower the upper horn while moving the lower horn until the working faces meet evenly, then lock the machine's locking handle.    
    h) Press the emergency raise button to lift the horn, then rotate the stop screw to lower it by about 2 mm (exact value depends on the workpiece), so that during operation the stop screw is clear of the lift table. But when there is no workpiece in the lower horn, the stop screw will prevent the upper and lower horns from touching, protecting the machine from damage.    
    i) Fix the lower horn to the worktable with screw hold-downs.    
    j) The above is the alignment procedure. For finer alignment, observe while test-welding and adjust at the same time: place carbon paper between the workpiece and the upper horn, and observe the impression on the white paper after the upper horn presses down; from the depth of the impression, shim under the lower horn with thin shims so the workpiece's welding surface bears pressure evenly.    
    k) For models with plane-adjustment screws, follow the horn direction and level adjustment method.