Ultrasonic Plastic Welding Processes:
The ultrasonic plastic welding machine is a high-tech product — a new generation of high-efficiency, high-quality, automated plastic welding equipment integrating microcomputer, ultrasonic, electronic, and mechanical technologies. When welding plastic workpieces, ultrasonic welding needs no adhesives or solvents and no heat source, offering easy operation, fast welding speed, good weld quality, and environmental safety.
The mechanical drive and electrical control systems of the ultrasonic plastic welding machine are equally advanced. First, an air compressor feeds about 5KG of air pressure into the pneumatic circuit; the electrical control system then operates the directional valve to raise or lower the horn as needed. The electrical control system also governs pre-pressing, ultrasonic triggering, and weld hold time. A dedicated microcomputer control system can be fitted to automate the whole sequence — start, horn up/down, ultrasonic triggering, pre-pressing, and weld hold time — and to calculate, store, and select the optimal ultrasonic power, pressure, and weld time for different workpieces, reliably assuring weld quality.
Because plastic welding targets differ in material, size, shape, and weld requirements, and because weldability is also affected by elastic modulus, vibration resistance, friction coefficient, thermal conductivity, and melting temperature, a range of ultrasonic plastic welding processes has been developed to improve weld quality.
1. Standard two-plane ultrasonic welding, where a tapered energy director strip runs across the entire lower weld face to concentrate energy. For high-hardness, low-melting-point materials, the strip must be at least 0.25MM tall; for low-hardness, high-melting-point materials, at least 0.5MM tall.
2. Ultrasonic groove-type molded-part welding, which uses offset spacing to prevent overheating and decomposition at the joint. Because the mating faces keep a certain clearance, welding is more difficult, so the mating faces should be designed with some clearance to lower the precision requirements for the molded parts. Ultrasonic cut-and-seal welders suit welds requiring a complete hermetic seal, especially for crystalline resins such as nylon and high-density polyethylene. The process first melts the initial contact area, then, under the welder’s controlled downward pressure, progressively melts the remaining material along the vertical parting face.
3. Ultrasonic insert welding — a new process for embedding metal elements in plastic, replacing the old stress-prone method of insert molding around metal elements. In insert welding, the fit tolerance between the plastic part and the embedded metal is generally about 0.4MM. To increase pull-out strength, the embedded metal surface can be knurled or threaded, or given several narrow grooves; for still greater strength, its axial surface can be knurled. Two workable insert arrangements exist: one with the plastic part against the horn, the other with the metal insert against the horn.
4. Ultrasonic stake welding, which uses controlled melting to form plastic studs that fasten the other half of the assembly. Ultrasound applied to the top of the stud melts the plastic to fill the horn cavity, forming a raised cap that locks the component. The horn should descend gently onto the stud to avoid sudden excessive pressure and accidental deformation. In the most common stake form, melting starts at the tip of the horn cavity, and the horn diameter is generally designed at twice the stud diameter. Small-diameter studs and abrasion-resistant thermoplastics use a domed-cap stake; where appearance and strength requirements are modest, a knurled stake can be used; and countersunk staking suits parts whose weld face must stay flat with no stud protrusion.