PE-HD High-density polyethylene
Chemical and Physical Properties:
The high crystallinity of PE-HD gives it high density, tensile strength, heat deflection temperature, viscosity, and chemical stability.
PE-HD has stronger permeation resistance than PE-LD. PE-HD has lower impact strength. The properties of PE-HD are mainly controlled by density and molecular weight distribution. PE-HD grades for injection molding have a very narrow molecular weight distribution. For densities of 0.91~ 0.925g/cm3, we call it Type 1 PE-HD; for densities of 0.926~ 0.94g/cm3, Type 2 PE-HD; for densities of 0.94~ 0.965g/cm3, Type 3 PE-HD.
Plastic Properties:
This material flows very well, with an MFR between 0.1 and 28. The higher the molecular weight, the poorer the flow properties of PE-LD, but the better its impact strength.
PE-LD is a semi-crystalline material that shows relatively high post-molding shrinkage, between 1.5% and 4%.
PE-HD is prone to environmental stress cracking. Using very low-flow materials reduces internal stress and thus mitigates cracking. Above 60C, PE-HD dissolves readily in hydrocarbon solvents, though its solvent resistance is still somewhat better than that of PE-LD.
Injection Molding Process Conditions:
Drying: not required if stored properly.
Melt temperature: 220~260C. For higher-molecular-weight materials, a melt temperature range of 200~250C is recommended.
Mold temperature: 50~95C. Parts with wall thickness below 6mm should use a higher mold temperature; parts over 6mm should use a lower mold temperature. Part cooling temperature should be uniform to minimize shrinkage differences. For optimal cycle time, the cooling channel diameter should be no less than 8mm and its distance from the mold surface should be within 1.3d (where “d” is the cooling channel diameter).
Plastic Properties:
Injection pressure: 700~1050bar.
Injection speed: high-speed injection recommended.
Runners and gates: runner diameter between 4 and 7.5mm; runner length as short as possible. All gate types can be used; gate length should not exceed 0.75mm. Especially well suited to hot runner molds.
Typical Applications:
Refrigerator containers, storage containers, household kitchenware, sealing caps, etc.