Inspecting the Ultrasonic Plastic Welding Machine:
To achieve the best results and maintain the machine's performance, tuning the resonance of the generator and transducer system is very important.
A. Before tuning, ensure the horn and the secondary booster are locked tight. During tuning, the horn must not touch anything else.
B. Turn on the power switch; the power indicator lights up.
C. Press the ultrasonic test switch and watch the load meter (if the ammeter needle exceeds 30% or 2 A, keep the ultrasonic test switch pressed only very briefly). Adjust the tuning inductor, rotating left and right until the load meter indicates the minimum position — usually between 5%–15% or 300 mA–900 mA.
D. Since this machine has a detent, the tuning inductor's adjustment range is only 360 degrees. If the horn's frequency differs greatly from 20 kHz or 15 kHz, open the cover and remove the detent for adjustment.
Calibrating the Ultrasonic Plastic Welding Machine:
For high production efficiency, the distance between the horn and the plastic part should be as short as possible while still leaving enough room to load and unload the plastic part.
A. Place the plastic part in the base, adjust air pressure to about 2 kg, and use the horn up/down switch to align the upper and lower molds.
B. Select a suitable distance between the horn and the plastic part, and lock the frame's fixing handle.
C. Adjust the limit bolt so that about 0.2 mm of space remains after the horn descends and presses the plastic part. (For plastic parts requiring greater weld depth, increase this space accordingly.)
D. Adjust welding time, hold time, and air pressure, and weld a test sample.
Inspect the sample: if welding is uneven, fine-tune the base's balance. The general rule is that where the weld is fused more severely, that side should be lowered, and the opposite side of the base raised with shims such as paper, so the plastic part mates well with the horn.