1. Delay time setting: adjusts when oscillation starts — oscillation begins 0–9.99 seconds after the limit switch actuates.
    2. Weld time setting: adjusts the length of weld time — oscillation for 0–9.99 seconds after the delay time ends.
    3. Hold time setting: adjusts the cooling/setting time of the workpiece weld after oscillation ends — within 0–9.99 seconds.
    4. Counter: records the number of work cycles, with a reset button.
    5. Regulator and pressure gauge: indicates working pressure and adjusts pressure.
    6. Sonic adjustment: adjusts the resonance match between the vibrator system and the oscillation circuit for ideal conversion efficiency.
    7. Amplitude meter: displays the amplitude level of the sound wave under no-load or loaded operation.
    8. Power switch and lamp: controls the power switch and signals the open-circuit indicator.
    9. Selector switch (auto / manual / sonic test): selects auto or manual, and the button for no-load sonic inspection.
    10. Sonic output adjustment knob: sets the sonic output level — levels 1–2 for general use, 3–4 for high-power output.
    11. Sonic overload lamp: indicates abnormal sonic overload; perform sonic adjustment until the overload lamp no longer lights.
    12. Frequency indicator: displays the machine frequency when tuning the machine.
    13. Horn: transmits vibration energy to the workpiece to weld it.
    14. Up/down cushion adjustment: the adjustment hole is on the side of the machine and can be adjusted so that lifting inertia is moderate.
    15. Down speed adjustment: adjusts to a reasonable, appropriate downward working speed.
    16. Weld position window: inspects how the horn presses the workpiece during normal welding.
    17. Bottom-dead-center fine adjustment screw: used when welding melt blocks or when outer dimensions must be precise — limits cylinder descent.
    18. Level fine adjustment screws: adjusting these four screws lets the horn press evenly on the workpiece.
    19. Output cable and socket: connects the machine's vibrator system to the oscillator box wiring.
    20. Control cable and socket: connects the machine's control unit to the oscillator box automatic control circuit.
    21. Ground nut: connects the ground wire of the electronic circuit — safety protection in case of leakage.
    22. Fuse holder: overload protection for the electronic circuit.