The specific steps for adjusting an ultrasonic mold are as follows:
    (1) First turn on the working air supply of the ultrasonic equipment, ensuring the equipment's air pressure gauge reads normally.
    (2) Use the dedicated wrench to remove the existing welding mold from the equipment and install the ultrasonic mold for the product to be welded (clockwise loosens — be sure to tighten it). Note: tighten the mold screws first.
    (3) Power on the ultrasonic equipment, press the start button and wait five seconds, then power off; immediately press the sonic test button on the controller and listen for the ultrasound from the machine (the sound should be crisp, with no hoarseness or extraneous noise; if the sound is hoarse or screeching, check the mold for cracks or looseness and take corrective action.
    (4) Loosen the two fastening handles behind the machine frame and crank the machine head up to a certain height. (Depending on product height.)
    (5) Shut off the air supply. (Adjust the air pressure controller to "zero".)
    (6) Place the product to be welded on the bottom mold, ensuring the mold closes.
    (7) Pull down the whole mold oscillator cylinder so the upper mold approaches the bottom mold; crank the machine head lift so the upper mold presses onto the product, keeping the product matched with the upper and lower molds.
    (8) Raise the air pressure to 0.1 mpa, set the selector switch to manual, and press the two green start buttons so the mold descends and presses the product.
    (9) Crank the lift to keep a 1MM gap between the limit screw and the oscillator cylinder. (Adjust for the product being welded.)
    (10) Tighten the frame fastening handles, fix the bottom mold, and press the red emergency stop button to raise the machine head.
    (11) Set the selector switch to automatic, adjust the product's welding parameters and time, and prepare for production.