1. The pattern wheel (horn) of the ultrasonic lace machine is wear-resistant, and the pattern molds are easy to mount and remove for flexible use;
2. The pattern wheel is machined from special alloy steel, and complex floral patterns of all kinds can be developed to customer requirements.
1. Pattern Wheel Installation:
When installing the pattern wheel, the mold frame must be in the raised position. Remove the left cover plate of the pattern-wheel mold frame, fit the pattern wheel, then refit the left cover plate and tighten the screws. Lower the pattern-wheel frame until the pattern wheel contacts the mold, and adjust the eccentric wheel so the working face of the pattern wheel is parallel to the working face of the mold.
2. Pattern Wheel Adjustment:
1) Place a sheet of A4 paper between the pressure roller and the pattern wheel, set the pressure to 1.5 KG, and turn the pattern-wheel cylinder adjusting nut upward to release it so it is no longer limiting. Set the upper/lower mold speed knobs to scale position 2 and the output power to position 4. Press the pressure-roller switch, step on the pattern-wheel pedal and then the foot pedal; after the pattern wheel has completed at least one full revolution, release it. Step on the pattern-wheel pedal again to raise the pattern wheel while pressing the pressure-roller switch to raise the pressure roller. Remove the paper and check whether the embossed pattern is even.
2) If the pattern is uneven, first loosen the eccentric-wheel locking screw on the left cover plate of the mold frame, then rotate the eccentric wheel (clockwise moves the pattern wheel upward; counterclockwise moves it downward), lock the eccentric wheel, and repeat the above steps until the pattern is even.
3) After leveling the pattern wheel with A4 paper, turn the pattern-wheel cylinder adjusting nut downward to limit it so the pattern wheel just touches the steel die. (This prevents the pattern wheel from sliding down and colliding with the steel die, which would cause wear.)
4) Adjust the pattern-wheel pressure according to the thickness of the material being sewn or embossed: increase the pressure for thicker materials and decrease it for thinner ones. 5) Depending on the material to be cut-sealed, its thickness, and the complexity of the pattern-wheel design, adjust the following three factors together for ideal cut-sealing results: (1) pattern-wheel linear speed; (2) pattern-wheel pressure; (3) ultrasonic power.
1. At lower pattern-wheel speeds, the material is exposed to ultrasonic energy for a longer time, and the pattern wheel stays in contact with the steel die longer, making cut-sealing easier.
2. At higher pattern-wheel pressures, the material receives more ultrasonic energy, making cut-sealing easier. (Wear on the die from the pattern wheel also increases.)
Pattern Wheel Inspection:
The pattern-wheel design must stay sharp, with a hardness of HRC 60~61°. Worn or rusted pattern wheels must not be used, to protect product quality and to avoid accelerated wear of the steel die from increased pattern-wheel pressure.
Pattern-Wheel Pressure Control:
1. For complex patterns, the pressure may be increased.
2. For patterns that have lost sharpness, the pressure may be increased.
3. If the ultrasonic amplitude of the steel die is low, the pressure may be increased.
4. For materials with high synthetic-fiber content (e.g., NYLON), reduce the pressure; for materials such as TC fabric, increase it.
5. For thick materials, the pressure may be increased.
6. Given the same quality and processing speed, lower pattern-wheel pressure is better. (Lower pressure means less wear on the steel die and pattern wheel, and a longer machine life.)
PreviousGeogrid Production Line 、 Geogrid Welding Machine 、 Geogrid Welding MachineNextBattery Box Hot Plate Welding Machine